3D print Room

Training Requirements

Whilst all use of Tools and Equipment is at your own risk each one will have a colour code denoting how much knowledge is required to operated it

• RED - You must be inducted by the maintainer / trainer and signed off as being competent
• ORANGE - You must read all the provided information and assess yourself as being competent of using the tool safely, if in doubt ask the area maintainer or other member for help
• GREEN - Fill your boots

Comparison of PLA vs ABS vs PETg

An article comparing ABS and PETg

https://all3dp.com/2/petg-vs-abs-3d-printing-filaments-compared/

AN article comparing PETg and PLA

https://all3dp.com/2/petg-vs-pla-3d-printing-filaments-compared/

Comparison of 3d print filament materials

PLA

biodegradable, lower temperature, less toxic. specific brands vary considerably (~10%?)

ABS

more toxic, stronger? needs heated bed

• instructables link looking at 3d print toxicity

P2 pg a.... something

no idea. new

Resin: white

brittle, not as strong, needs UV curing (in water) after print

wanhao d7

Technology: DLP (Digital Light Processing)
Build Volume: 120 x 68 x 180mm
Layer Resolution: 35 microns
Printable materials: 405 NM UV resin

Raspberry pi runs NanoDLP, which is the software which sends the 'plates' to the printer. Connect to NanoDLP from the hackspace computer, or on a computer on the same network.

D7 page

Airbrush (somewhere)

"we have a spray booth and i have a fan and tube i can donate"