3D print Room
Revision as of 08:06, 30 September 2020 by Ben Norcutt (talk | contribs)
Contents
Training Requirements
Whilst all use of Tools and Equipment is at your own risk each one will have a colour code denoting how much knowledge is required to operated it
- RED - You must be inducted by the maintainer / trainer and signed off as being competent
- ORANGE - You must read all the provided information and assess yourself as being competent of using the tool safely, if in doubt ask the area maintainer or other member for help
- GREEN - Fill your boots
wanhao d7
Technology: DLP (Digital Light Processing)
Build Volume: 120 x 68 x 180mm
Layer Resolution: 35 microns
Printable materials: 405 NM UV resin
Raspberry pi runs NanoDLP, which is the software which sends the 'plates' to the printer. Connect to NanoDLP from the hackspace computer, or on a computer on the same network.
Ultimaker 2
Ender
CR-10
Printer
Hackspace PC
Resin Cure stuff
Fridge of filaments + other nick-nacks
Airbrush (somewhere)
"we have a spray booth and i have a fan and tube i can donate"
