Difference between revisions of "3D print Room"
Jump to navigation
Jump to search
Nicholas w (talk | contribs) |
Nicholas w (talk | contribs) m (airbrush not on alans spreadsheet) |
||
| Line 16: | Line 16: | ||
== Printer == | == Printer == | ||
| + | |||
| + | == Hackspace PC == | ||
===== Resin Cure stuff ===== | ===== Resin Cure stuff ===== | ||
| Line 21: | Line 23: | ||
===== Fridge of filaments + other nick-nacks ===== | ===== Fridge of filaments + other nick-nacks ===== | ||
| − | == | + | ===== Airbrush (somewhere) ===== |
| + | "we have a spray booth and i have a fan and tube i can donate" | ||
Revision as of 10:06, 16 September 2020
Contents
wanhao d7
Technology: DLP (Digital Light Processing)
Build Volume: 120 x 68 x 180mm
Layer Resolution: 35 microns
Printable materials: 405 NM UV resin
Raspberry pi runs NanoDLP, which is the software which sends the 'plates' to the printer. Connect to NanoDLP from the hackspace computer, or on a computer on the same network.
Ultimaker 2
Ender
CR-10
Printer
Hackspace PC
Resin Cure stuff
Fridge of filaments + other nick-nacks
Airbrush (somewhere)
"we have a spray booth and i have a fan and tube i can donate"
