Difference between revisions of "3D print Room"
Jump to navigation
Jump to search
Nicholas w (talk | contribs) |
Nicholas w (talk | contribs) |
||
| Line 15: | Line 15: | ||
Raspberry pi runs NanoDLP, which is the software which sends the 'plates' to the printer. Connect to NanoDLP from the hackspace computer, or on a computer on the same network. | Raspberry pi runs NanoDLP, which is the software which sends the 'plates' to the printer. Connect to NanoDLP from the hackspace computer, or on a computer on the same network. | ||
| − | [[equiptment_info_wanhao_d7 D7 page]] | + | [[equiptment_info_wanhao_d7 | D7 page]] |
== Ultimaker 2 == | == Ultimaker 2 == | ||
Revision as of 11:05, 12 October 2020
Contents
Training Requirements
Whilst all use of Tools and Equipment is at your own risk each one will have a colour code denoting how much knowledge is required to operated it
- RED - You must be inducted by the maintainer / trainer and signed off as being competent
- ORANGE - You must read all the provided information and assess yourself as being competent of using the tool safely, if in doubt ask the area maintainer or other member for help
- GREEN - Fill your boots
wanhao d7
Technology: DLP (Digital Light Processing)
Build Volume: 120 x 68 x 180mm
Layer Resolution: 35 microns
Printable materials: 405 NM UV resin
Raspberry pi runs NanoDLP, which is the software which sends the 'plates' to the printer. Connect to NanoDLP from the hackspace computer, or on a computer on the same network.
Ultimaker 2
Ender
CR-10
Printer
Hackspace PC
Resin Cure stuff
Fridge of filaments + other nick-nacks
Airbrush (somewhere)
"we have a spray booth and i have a fan and tube i can donate"
