Ender3 Info - Revision history

Nicholas w at 13:30, 4 August 2021

2021-08-04T13:30:50Z

2021-08-04T13:25:37Z

2021-03-24T09:29:35Z

Created page with "Worth checking the bed is level. A piece of paper should slide between the extruder and bed, but be a little bit gripped by it."

New page

Worth checking the bed is level.
A piece of paper should slide between the extruder and bed, but be a little bit gripped by it.

← Older revision		Revision as of 13:30, 4 August 2021
Line 6:		Line 6:
	*cura		*cura
	*Prusa slic3r		*Prusa slic3r
		+
		+	===== random blah: =====
		+	With the holes, I use 0.2 as a Tolerance - so make the hole 0.2mm larger than the thing. <br/>
		+	But side-holes are going to be less circular due to the layers. And you can always cut material away. <br/>
		+	I very rarely print at 100% infill, usually 30% or something. It's quicker, and usually fine. <br/>
		+	Depends what it is. Also, huge lumps of solid prints can warp as they cool (the top shrinks, and they bow)<br/>
		+	(the bottom does not shrink because it's on a heated plate)<br/>

← Older revision		Revision as of 13:25, 4 August 2021
Line 1:		Line 1:
−	Worth checking the bed is level.	+
		+	Worth checking the bed is level. <br/>
	A piece of paper should slide between the extruder and bed, but be a little bit gripped by it.		A piece of paper should slide between the extruder and bed, but be a little bit gripped by it.
		+
		+	slicer software:<br/>
		+	*cura
		+	*Prusa slic3r